Endorphines Grand Terminal

Dual 8 mode VCF / VCA, dual voltage controlled AD/AR/looping envelope, 16 algorithm stereo FX processor

Dual multi-mode filter (ladder, diode, vactrol, state-variable lp/hp/bp and comb) in dual, stereo and serial modes
Dual AD/ASR/looping envelope generator that acts as band-limited oscillator when cycling at linear slopes
Stereo “Cabin Pressure” processor with different 16 effects: from shimmered halls and reverberations to a spring simulation over tape/ping-pong delays / chorus / distortion / compressor and others.

Separate mono modular level output and stereo line level output for direct line recording or driving the headphones.
Easy firmware update via Audio.

Fully compatible with GatewayT_XP

Audio I/O: 48 kHz 16 bit, 32 bits internal processing

Power consumption:
230 mA +12V
65 mA -12V
0 mA 5V

26 HP
26 mm deep


My Grand Terminal is behaving strangely. Can't change fx or vcf types. Signal is too low or distorted.
Press all four knobs at once and hold them for more than 4 seconds. This is a soft reset and brings the module back to the factory settings.

I have small noise in my audio output in a certain cases? 
Try the following PSU adapter for your modular case: 15V Meanwell GST90A15

How can I replace the panel with other color?
Check the endorphines website and panels replacement guide. Also don’t forget the knobs and buttons.

Rainbow cable pinout. Side red/brown pair of pins always correspond to -12V similar as with typical gray ribbon cable.
  • Manufacturer's warranty
  • Pre-orders ship 1-2 days after arrival in NZ
  • Free NZ/AU shipping on all orders over NZ$299
  • Free worldwide shipping on all orders over USD$499
More Videos

Manufacturer Endorphines
Status In stock
Functionality Filter VCF, Envelope Generator